Fault code group
AdBlue / SCR Fault Codes
The SCR (selective catalytic reduction) system injects AdBlue (urea solution) into the exhaust to convert nitrogen oxides into nitrogen and water vapour. The control unit monitors AdBlue level and quality, the pump and dosing valve, the heaters and the conversion efficiency, and stores a fault code when one of them leaves the expected range. On many vehicles the driver is then warned and performance may be limited.
System
What does this system do?
The SCR (selective catalytic reduction) system injects AdBlue (urea solution) into the exhaust to convert nitrogen oxides into nitrogen and water vapour. The control unit monitors AdBlue level and quality, the pump and dosing valve, the heaters and the conversion efficiency, and stores a fault code when one of them leaves the expected range. On many vehicles the driver is then warned and performance may be limited.
A fault code is a symptom; on its own it does not tell you the cause. First check live data with a diagnostic tool and inspect wiring, connectors and components. A software operation does not replace fault diagnosis and repair.
Code search
Look up a fault code
If the code has its own page you go straight to it; if it is only listed in a group table you go to its row.
Code list
AdBlue / SCR fault codes
| Description | Code |
|---|---|
| Reductant Control Module System Voltage | P056D |
| Cold Start SCR NOx Catalyst Inlet Temperature Too Low | P05EB |
| Reductant Heater Control Module Supply Voltage | P05ED |
| Reductant Pump Supply Voltage – Circuit/Open | P05EE |
| Reductant Pump Supply Voltage – Circuit Low | P05EF |
| Reductant Pump Supply Voltage – Circuit High | P05F0 |
| Reductant Pump Supply Voltage – Stuck On | P05F1 |
| Reductant Pump Supply Voltage – Stuck Off | P05F2 |
| Reductant Heater Control Module Performance | P05F8 |
| Reductant System Malfunction Lamp Control Circuit | P065D |
| Reductant Control Module Internal Temperature Sensor Circuit | P06F0 |
| NOx Trap Efficiency Below Threshold (Bank 1) | P2000 |
| NOx Trap Efficiency Below Threshold (Bank 2) | P2001 |
| Reductant Pump A Stuck On | P201F |
| Reductant Injection Air Pressure Sensor – Circuit | P2037 |
| Reductant Injection Air Pressure Sensor – Range/Performance | P2038 |
| Reductant Injection Air Pressure Sensor – Circuit Low | P2039 |
| Reductant Level Sensor – Circuit | P203A |
| Reductant Level Sensor – Range/Performance | P203B |
| Reductant Level Sensor – Circuit Low | P203C |
| Reductant Level Sensor – Circuit High | P203D |
| Reductant Level Sensor – Intermittent/Erratic | P203E |
| Reductant Level Too Low | P203F |
| Reductant Injection Air Pressure Sensor – Circuit High | P2040 |
| Reductant Injection Air Pressure Sensor – Intermittent | P2041 |
| Reductant Temperature Sensor – Circuit | P2042 |
| Reductant Temperature Sensor – Range/Performance | P2043 |
| Reductant Temperature Sensor – Circuit Low | P2044 |
| Reductant Temperature Sensor – Circuit High | P2045 |
| Reductant Temperature Sensor – Intermittent | P2046 |
| Reductant Injection Valve (Bank 1 Unit 1) – Circuit/Open | P2047 |
| Reductant Injection Valve (Bank 1 Unit 1) – Circuit Low | P2048 |
| Reductant Injection Valve (Bank 1 Unit 1) – Circuit High | P2049 |
| Reductant Pressure Sensor – Circuit | P204A |
| Reductant Pressure Sensor – Range/Performance | P204B |
| Reductant Pressure Sensor – Circuit Low | P204C |
| Reductant Pressure Sensor – Circuit High | P204D |
| Reductant Pressure Sensor – Intermittent/Erratic | P204E |
| Reductant System (Bank 1) – Performance | P204F |
| Reductant Injection Valve (Bank 2 Unit 1) – Circuit/Open | P2050 |
| Reductant Injection Valve (Bank 2 Unit 1) – Circuit Low | P2051 |
| Reductant Injection Valve (Bank 2 Unit 1) – Circuit High | P2052 |
| Reductant Injection Valve (Bank 1 Unit 2) – Circuit/Open | P2053 |
| Reductant Injection Valve (Bank 1 Unit 2) – Circuit Low | P2054 |
| Reductant Injection Valve (Bank 1 Unit 2) – Circuit High | P2055 |
| Reductant Injection Valve (Bank 2 Unit 2) – Circuit/Open | P2056 |
| Reductant Injection Valve (Bank 2 Unit 2) – Circuit Low | P2057 |
| Reductant Injection Valve (Bank 2 Unit 2) – Circuit High | P2058 |
| Reductant Injection Air Pump Control – Circuit/Open | P2059 |
| Reductant Tank Temperature Sensor – Circuit | P205A |
| Reductant Tank Temperature Sensor – Range/Performance | P205B |
| Reductant Tank Temperature Sensor – Circuit Low | P205C |
| Reductant Tank Temperature Sensor – Circuit High | P205D |
| Reductant Tank Temperature Sensor – Intermittent/Erratic | P205E |
| Reductant System (Bank 2) – Performance | P205F |
| Reductant Injection Air Pump Control – Circuit Low | P2060 |
| Reductant Injection Air Pump Control – Circuit High | P2061 |
| Reductant Supply Control – Circuit/Open | P2062 |
| Reductant Supply Control – Circuit Low | P2063 |
| Reductant Supply Control – Circuit High | P2064 |
| Reductant Quality Sensor – Circuit | P206A |
| Reductant Quality Sensor – Range/Performance | P206B |
| Reductant Quality Sensor – Circuit Low | P206C |
| Reductant Quality Sensor – Circuit High | P206D |
| Reductant Quality Performance | P207F |
| Reductant Pump Control – Circuit/Open | P208A |
| Reductant Pump Control – Range/Performance | P208B |
| Reductant Pump Control – Circuit Low | P208C |
| Reductant Pump Control – Circuit High | P208D |
| Reductant Injection Valve (Bank 1 Unit 1) – Stuck Closed | P208E |
| Reductant Purge Control Valve – Circuit/Open | P20A0 |
| Reductant Purge Control Valve – Performance | P20A1 |
| Reductant Purge Control Valve – Circuit Low | P20A2 |
| Reductant Purge Control Valve – Circuit High | P20A3 |
| Reductant Injection Air Pressure Control Valve – Circuit Low | P20A8 |
| Reductant Heater A Control – Circuit/Open | P20B9 |
| Reductant Heater A Control – Performance | P20BA |
| Reductant Heater A Control – Circuit Low | P20BB |
| Reductant Heater A Control – Circuit High | P20BC |
| Reductant Heater B Control – Circuit/Open | P20BD |
| Reductant Heater B Control – Performance | P20BE |
| Reductant Heater B Control – Circuit Low | P20BF |
| Reductant Heater B Control – Circuit High | P20C0 |
| Reductant Heater C Control – Circuit/Open | P20C1 |
| Reductant Heater C Control – Performance | P20C2 |
| Reductant Heater C Control – Circuit Low | P20C3 |
| Reductant Heater C Control – Circuit High | P20C4 |
| Reductant Heater D Control – Circuit/Open | P20C5 |
| Reductant Heater D Control – Performance | P20C6 |
| Reductant Heater D Control – Circuit Low | P20C7 |
| Reductant Heater D Control – Circuit High | P20C8 |
| Reductant Pressure – Too Low | P20E8 |
| Reductant Pressure – Too High | P20E9 |
| SCR NOx Catalyst Efficiency Below Threshold (Bank 1) | P20EE |
| Reductant Consumption – Too Low | P20F4 |
| Reductant Consumption – Too High | P20F5 |
| Reductant Level Sensor B – Intermittent/Erratic | P21AC |
| Reductant Tank Cap Switch – Range/Performance | P24CC |
| Reductant Purge Control Valve B – Stuck Closed | P24E0 |
| NOx Exceedance – Empty Reagent Tank | P2BA7 |
| NOx Exceedance – Interruption of Reagent Dosing Activity | P2BA8 |
| NOx Exceedance – Low Reagent Consumption | P2BAA |
| NOx Exceedance – Deactivation of EGR | P2BAC |
| NOx Exceedance – NOx Control Monitoring System | P2BAE |
Linked codes have their own page; the others are listed in this table only.
Related operations
Software operations related to this system
Help
Frequently asked questions
What do AdBlue / SCR fault codes indicate?
The SCR (selective catalytic reduction) system injects AdBlue (urea solution) into the exhaust to convert nitrogen oxides into nitrogen and water vapour. The control unit monitors AdBlue level and quality, the pump and dosing valve, the heaters and the conversion efficiency, and stores a fault code when one of them leaves the expected range. On many vehicles the driver is then warned and performance may be limited.
Does switching off a fault code fix the fault?
No. Switching a code off in software does not remove the cause of the fault. Diagnose and repair the fault first. Operations on emission systems such as DTC off are offered only for use permitted by local law (e.g. off-road / motorsport / export).
Where do the code descriptions on these pages come from?
The code titles are based on the generic SAE J2012 / ISO 15031-6 code definitions and written in our own words. Manufacturer-specific codes are not listed. The ECU families come from fault code tables verified in EcuPrime.
Start today
A free account for dealers and tuning pros: upload your file, see which operations work, apply your solution.
Create free account